Table of Contents
Advertisement
Interactive Method
If you want the setup program to
prompt you, perfonn the following
steps:
1. Place your software driver diskette
in a floppy drive, and change to
the drive containing the diskette.
2. Type the following:
ezsetup [ENTER]
3. Follow the instructions displayed
on the screen.
C o m m a n d l i n e Method
If you are familiar with EZSETUP and
want to skip the interactive prompts,
you may use a command line to
change the values associated with
the soft setting. The command line
consists of three components: the
30
command, ezsetup, the adapter iden-
tification (required only when more
than one adapter is installed), and the
configuration parameters. The adapt-
er identification can be either the I/O
base address or the node address.
The command for identifying the
adapter using the node address is
/node:x,where x is the adapter's 12-
digit node address.
Table 5 provides two examples of
properiy constructed command lines;
and Table 6 provides a detailed
description of each option.
Notice that for each example in Table
5, the command ezsetup starts the
setup program, the adapter identifica-
tion, if specified, tells the system
which adapter is to be configured,
and the remaining infonnation tells
the system how to configure the
adapter.
In example 1, the IRQ level is changed
to 5 and the RAM base address is
changed to C8000. Notice in example
1 that the adapter identification is
omitted. This is valid when there is
only one adapter installed in your com-
puter
Example No.
Example 1
Example 2
Command Lines
ezsetup /irq:5 /ram:C8000
ezsetup /io:240 /newio:280 /irq:5 /ram:COOOO /rom:D0000
Table 5. Command Line Examples
Advertisement
Table of Contents
