SMC Networks Elite16 Manual page 22

High performance 16-bit ethernet local area network adapters

Table of Contents

can be avoided using one of these

two choices.

If, however, both hardware settings

result in a conflict between the Ether-

net adapter and another option board

or computer function, you must

change the configuration of the other

board or computer function, or set the

Ethernet adapter jumper (Wl) to SOFT

and run the software setup program.

If neither of the two preconfigured set-

tings is satisfactory (or if you are in-

stalling more than two adapters in the

same computer), set the jumper to

SOFT and run the software setup pro-

gram to configure the adapter This

will enable you to choose from a

variety of differisnt configurations.

(Refer to the "Software Configuration"

section).

Configuration Settings

Tfie soft Jumfser setting Is

used to configure ttie adapter

using ttie setup program.

(IC Base Address = 240)

I/O Base Address = 280

IRQ = 3; Enabled

R/Mvl Base Address = DOOOO

I/O Base Address = 300

IRQ = 10; Enabled

RAM Base Address = CCOOO

m o

Mciooy

SETTING

Table 4. Configuration Parameters - W l

Table of Contents

Elite16tElite16 combo