SMC Networks Elite16 Manual page 52

Loading LAN Manager
V.2.0
The procedures in this section are for
LAN Manager V2.0. For other installa-
tion and configuration instructions,
refer to your LAN Manager User's
manual.
The following instructions apply only to
installing the LAN Manager on a DOS
platform. Do not start LAN Manager
until after it's installed. Use the
Microsoft instructions to complete the
installation procedure. Microsoft in-
cludes support for the SMC PLUS fami-
ly adapters. Select the SMC adapter
from the list provided by Microsoft.
To Install the LAN Manager:
1, Copy the LAN Manager driver to the
driver directory used by LAN
Manager.
For example, when installing a LAN
Manager server or enhanced
workstation using the nonnal direc-
tory structure type:
COPY MACSMC.DOS C:\LAN-
MAN\DRIVERS\ETIIERNET
When installing a LAN Manager basic
workstation type:
COPY MACSMC.DOS C:\LAN-
MAN
2. Modify the PROTOCOL.INI in accord-
ance with the adapter type.
a. For jumper-configured adapters,
use a text editor to add the
following lines to the file:
[MACSMC - F]
DriverName = MACSMC8
lOBase - 0x280
RAMAddresit - OxDOOO
I R Q - 3
Replace the above lOBase,
RAMAddress, and IRQ values
with the values appropriate for
your adapter card. If you aren't
sure which adapter type you
have, refer to Section 1.0 or use
the setup above. A more
complete explanation of these
parameters and their
appropriate values are provided
in section 5.0. If you have a
software-configurable or Micro
Channel adapter, you can
simplify your parameters by
using step 2b.
b. For software-configurable and
Micro Channel adapters, use a
text editor to add the following
lines to the file:
[MACSMC_MF]
DriverName = MACSMC6
3. Reboot the system and bring up LAN
Manager using the instructions
supplied by the LAN Manager ven-
dor
55