SMC Networks Elite16 Manual page 50

Loading NetWare 3 8 6
V 3 . l l
7, To change the protocol name, use the
line in NEICFG which reads:
Protocol name ID
name type
where name is the protocol name, ID'\s
the protocol ID number, and
name type is the frame type being
used for the protocol.
For example.
Protocol IPX 8 1 3 7 E t h e m e t J I
indicates that the protocol name is
being changed to IPX - designated
protocol ID 8137 - within the Ether-
net 1 1 frame type,
8, To reassign the link-level frame type,
use the line in NEICFG which
reads either:
Frame name
or
Envelope Type name
For example, if you type this line.
Frame E'niERNET_802.2
The frame type is reassigned as Ether-
net 802,2, The default frame type
is ETHERNET_802,3,
For additional instructions, refer to the
NetWare ODI Shell for DOS manual
and the sections entitled "Install ODI
workstations" and "Customize ODI
workstation configurations with
NEICFG" in the NetWare Users
Manual.
To Generate a Server for
NetWare 3 8 6 V 3 . l l :
The procedures in this section are for
NetWare 386 V3,11. Installation and
configuration for this version of Net-
Ware on the server is much easier, in-
volving a series of easy-to-use prompts
which apply for both woricstation and
sen/er installations.
If you want to install NetWare 386
from diskette, follow these instructions.
1, Make backup copies of both the
SYSTEM -1 and SYSTEM -2
diskettes.
2, Insert the SYSTEM -1 diskette into
drive A:,
3, Access drive a:.
4, Type: SERVER
53