To Generate A Workstation For Netware 286 V2,2 - SMC Networks Elite16 Manual

Continue to define each network board
in your server, until all boards are
defined.
15. When you're finished, press [FIO].
16. Cursor down the "Operating Sys-
temn Generation" screen until you
get to the channel option selec-
tions.
A list of channel options appears
immediately below the Network
Board selections.
17. Assign hard disk space for each
channel designated.
Follow all prompts and refer to the
Novell User's Manual for instruc-
tions on defining channels.
To Generate a Workstation for
NetWare 2 8 6 V2.2:
1. Make backup copies of the NetWare
LAN_DRV_200 and SMC Super-
Disk diskettes and store the
originals.
2. Insert the copy of the WSGEN floppy
into drive A:.
3. Access drive A:.
4. Type: WSGEN
and press [Enter] twice.
A list of available adapter boards ap-
pears on the screen.
5. Press [Insert].
6. Insert the SuperDisk diskette into
drive A: and press [Enter].
If the file was read successfully, a mes-
sage appears like this:
DRIVER FILE FOR SMC
ETHERCARD PLUS VXXX
READ SUCCESSFULLY.
where xxx is the version number
7. Press [Enter].
The SMC EtherCard PLUS board is now
installed and highlighted as shown
in Figure 12.
8. Press [Enter] to select this board.
A configuration screen like Figure 13 is
displayed.
9. Select the configuration setting that
matches the setting on your board
and press [Enter] to confimri your
choice.
Option 0, First Software Configured
Adapter, is recommended.
49