SMC Networks Elite16 Manual page 56

R O M Window Size a n d
B a s e Address
Most ROM devices designed to be
used with the Ethemet adapter re-
quire 16 Kbytes of address space. To
configure a 16-Kbyte ROM, move the
jumper at W2 to D8000 (refer to Table
7). This will enable the ROM to
respond to addresses in the range,
D8000 - DBFFF If this memory range
is occupied, you must set the W2
jumper back to NONE/SOF and use
the software setup program to estab-
lish the ROM base address at another
location.
If necessary, you can change the ROM
window size. The default setting,
when a ROM is enabled, is 16 Kbytes,
or 0 Kbytes when the ROM is dis-
abled. To change the window size for
a special purpose 32-Kbyte or 64-
Kbyte ROM device, you must use the
setup program. If you aren't sure
what size ROM you have, consult the
ROM's installation instmctions.
ROM Bate Addren
None/Soft
D8000
(UMd only with 16
Kbyte ROM devtee)
W2
Si
MCIORY
•TTwe
Table 7. Boot ROM Options
59