Using Netcfg - SMC Networks Elite16 Manual

If a NEICFG file already exists on the
directory, follow these steps to up-
date that file.
Append the new NEICFG file to the
old one using the DOS COPY com-
mand as follows:
copy c:\adi\net.cfg+a:net.cfg
c:\od i/net.cfg
This file is used to configure the entire
system, not just the driver
Using NET. CFG
To use and edit the NEICFG file, you
must do the following:
1. There is no need to use or edit the
NEICFG file if the SMC PLUS
adapter is an AI adapter con-
figured with the following default
settings:
Base I/O Address: 2 8 0
Interrupt IRQ: 3
RAM Base Address: DOOO.
2. If the adapter being used is software-
configurable, then only the Base
1/0 Address must be specified.
3. To change the base 1//0 address, use
the line in NET.CFG which reads
P o r t # l 2 8 0 2 0
and change 280 to the appropriate
Base I/O Address.
4. To change the IRQ, use the line in
NEICFG which reads:
I i i t # l 3
and change 3 to the appropriate IRQ.
5. To change the RAM Base Address,
use the line in NEICFG which
reads
Mem #1 OOODOOOO 2000/10
and change D O O O O to the appropriate
RAM Base Address. For example:
Mem #1 000C8000 2000/10
will cause the driver to use C8000 as
the RAM Base Address.
When using NET.CFG with Micro
Channel machines, use the PS/2
Slot entry. Find the line which
reads:
PS/2 Slot ?
and change the ? to the desired slot
number
Note: Ihe '#' in the first column of the
NEICFG file denotes an ignored
line. Remove this symbol from all
used lines and insert them into all
unused lines, or delete unused
lines altogether
52