Face Detection - EverFocus EZN Series User Manual

5.8.2.5 Face Detection

Only 5MP and 8MP models support this function. When IP Camera detects faces in a pre-defined area, the Face
Detection event will be triggered. You can configure some event actions like event recording, alarm output or
Email alert when an event is triggered.
Analysis
Switch: Switch the button to the right to enable the function.
Timeout Duration: After enabling the Alarm Out, select a timeout duration for the alarm output.
Post Recording: Select a post recording time when a Face Detection event is triggered.
Alarm Out: Switch the button to the right to enable the alarm output, and then further configure the Timeout
Duration above.
Send Email: Switch the button to the right to enable the Email alert function. When a Face Detection event is
triggered, the camera will send an email alert with a snapshot image to the pre-configured Email receiver. Note
that for this function to work, you have to set up the Email function in advance (refer to 5.5.3 Email).
Snapshot Mode: Select a snapshot mode.
Apply Mode: Select a apply mode.
Advance: Switch the button to the right to enable the advanced functions including Roll Range, Pitch Range,
Yaw Range, Picture Quality and Min Pixel.
Rule Number: Select a number to configure the areas.
Rule Switch: Switch the button to the right to enable the Rule Type setup below.
Rule Kind: Select a rule kind. Options include Area and Line.
Rule Type: Select a rule type.
Perimeter Intrusion Line-Crossing
Pedestrian Detection Face Detection
Face Detection
Level
Middle
Snapshot Mode
Real Time Mode
Apply Mode
Recognition Mode
Advance
Roll Range
30
Pitch Range
30
Normal
Yaw Range
45
Picture Quality
100
Min Pixel
64
Rect
Rule Kind
Value IP Series Network Cameras – H265, 2MP / 5MP / 8MP
Object Detection
Cross Counting
(0-180)
(0-180)
(0-180)
(0-100)
(32-1080)
64