Object Detection - EverFocus EZN Series User Manual

5.8.2.3 Object Detection

When IP Camera detects missing objects and foreign objects in a pre-defined area, the Foreign/Missing Object
Detection event will be triggered. You can configure some event actions like event recording, alarm output or
Email alert when an event is triggered.
Analysis
Switch: Switch the button to the right to enable the function.
Timeout Duration: After enabling the Alarm Out, select a timeout duration for the alarm output.
Post Recording: Select a post recording time when a Foreign/Missing Object event is triggered.
Sensitivity: Select a sensitivity for the Foreign/Missing Object Detection. The larger the value, the higher the
sensitivity.
Scene: Select Indoor or Outdoor based on the location where your IP camera is installed.
Alarm Out: Switch the button to the right to enable the alarm output, and then further configure the Timeout
Duration above.
Send Email: Switch the button to the right to enable the Email alert function. When a Foreign/Missing Object
event is triggered, the camera will send an email alert with a snapshot image to the pre-configured Email
receiver. Note that for this function to work, you have to set up the Email function in advance (refer to 5.5.3
Email).
Rule Number: Select a number to configure the areas. Up to 4 areas can be configured.
Rule Switch: Switch the button to the right to enable the Rule Type setup below.
Rule Type: Select a rule type.
Enable Recording: Switch the button to the right to enable the Foreign/Missing Object Detection recording
function. Note that for Foreign/Missing Object Detection recording function to work, the Record Schedule
function has to be configured (please refer to 5.8.1 Record Schedule).
Click Refresh to refresh the page; click Apply to save the settings.
Perimeter Intrusion Line-Crossing
Pedestrian Detection Face Detection
Value IP Series Network Cameras – H265, 2MP / 5MP / 8MP
Object Detection
Cross Counting
60