3.2
EZN Series
1 Optionally insert a micro SD card into the card slot on the rear panel of the camera. To do this, unscrew
the 2 screw, remove the SD card slot cover and then insert the micro SD card.
2 Drill three holes on the surface according to the Camera Base and then push the supplied 3 Screw
Anchors into the holes. Drill another hole in the middle within the 3 screw holes if you wish to run the
wires into the surface. Screw the camera to the surface using the supplied 3 Screws.
3 Adjust the pan/tilt/rotate angles of the camera by loosen the Pan/Tilt/Rotate screws using the supplied
Hexagon Wrench.
4 Connect the camera to power. You can either connect the camera to a 12VDC power source or to a PoE
switch using the PoE cable.
5 Connect the camera to the network using the supplied Cable Gland Kit. Please refer to Step 6 in 3.1
EHN Series.
6 Now you can access the camera live view. See 4. Accessing the Camera.
Value IP Series Network Cameras – H265, 2MP / 5MP / 8MP
Screw
Screw Anchor
Rotate Screws (both sides)
Tilt Screw
Pan Screw
9
Surface