Record; Record Setting - EverFocus EZN Series User Manual

5.3

Record

5.3.1

Record Setting

You can configure the record settings on this page. Please note that to enable the record function, a micro SD
card has to be inserted to the IP camera in advance. Please also format the micro SD card for the first-time use
(refer to 5.6.1 Storage).
Stream Mode: Select a recording stream mode.
Record: Switch the button to the right to enable the record function. Please note that to enable the record
function, a micro SD card has to be inserted to the IP camera in advance. Please also format the micro SD card
for the first-time use (refer to 5.6.1 Storage).
Pre-Record: Switch the button to the right to enable the pre-record function for all the alarm recordings. The
camera will start recording 10 seconds before the alarms occur.
Network Failed: Switch the button to the right to enable the network failed function. When the network is
disconnecting, the IP camera will start recording until the network connection is back to normal.
Click Refresh to refresh the page; click Apply to save the settings.
Note:
1. To configure the recording storage path, please refer to 5.7.7 Local Settings.
2. After setting up the Record settings, you can optionally set up the Record Schedule, please refer to 5.3.2
Record Schedule.
Value IP Series Network Cameras – H265, 2MP / 5MP / 8MP
26