Mitsubishi MELSEC Q Series Reference Manual page 150

(2) Turning OFF internal relay M50 and turning ON output relay Y2F
(Data name)
External device
side
(Example)
(Data name)
Programmable controller CPU side
(Example)
3 - 90
3 WHEN COMMUNICATING USING THE QnA COMPATIBLE 3E/3C/4C FRAMES OR 4E FRAME
while communicating in binary code
L H L
02 14 01
H H H
1402
H
POINT
(1) Designate the number of access points within the following range:
(a) When accessing the Q/LCPU on the station where the C24/E71 is
loaded (local station), or the Q/LCPU on the station connected on a Q/L
series supporting network system (CC-Link IE Controller Network, CC-
Link IE Field Network, MELSECNET/H, MELSECNET/10, or Ethernet)
(other station)
Number of device points
(b) When accessing the QnACPU (other station), or the QCPU/QnACPU
on the station connected on a QnA series supporting network system
(MELSECNET/10, or Ethernet) (other station)
Number of device points
(c) When accessing a programmable controller CPU other than the above
(other station)
Number of device points
(2) If there is system protection on a Q/L/QnACPU when attempting to write to it,
an error occurs and an error completion code is returned.
Write in bit unit
Number of points to be written
When set (ON) : 01
When reset (OFF) : 00
(Refer to Section 3.3.1.)
(3 Byte) (3 Byte)
H L - H L - H
(50)
00 02 32 00 00 90 00 2F 00 00 9D 01
H H H H H H H H H H H H
Number of bit access points
Turns
Turns
ON Y2F.
OFF M50.
: 1  number of device points  188
: 1  number of device points  94
: 1  number of device points  20
H
H
3 - 90