Mitsubishi MELSEC Q Series Reference Manual page 148

(2) Writing eight points from internal relays M100 to M107 while
(Data name)
External
device side
(Example)
(Data name)
Programmable controller CPU side
(Example)
3 - 88
3 WHEN COMMUNICATING USING THE QnA COMPATIBLE 3E/3C/4C FRAMES OR 4E FRAME
communicating in binary code
(Refer to Section 3.3.1.)
L H L H L
01 14 01 00 64 00
H H H H H
Specify the range
of the devices to be
1401
H
written
POINT
(1) Designate the number of device points within the following range:
(a) When accessing the Q/LCPU on the station where the C24/E71 is loaded
(local station), or the Q/LCPU on the station connected on a Q/L series
supporting network system (CC-Link IE Controller Network, CC-Link IE
Field Network, MELSECNET/H, MELSECNET/10, or Ethernet) (other
station)
Number of device points
1) Via the E71
2) Via the C24
(b) When accessing the QnACPU (other station), or the QCPU/QnACPU on
the station connected on a QnA series supporting network system
(MELSECNET/10, or Ethernet) (other station)
Number of device points
1) Via the E71
2) Via the C24
(c) When accessing a programmable controller CPU other than the above
(other station)
Number of device points
(2) Set the access range as follows
Access range
(3) If there is system protection on a Q/L/QnACPU when attempting to write to it,
an error occurs and an error completion code is returned.
Number of points to be written
Turns OFF when four bits are 0.
Turn ON when four bits are 1.
(Refer to Section 3.1.5.)
– H L H
00 90 08 00 11 00 11 00
H H H H H H H H H
Turns OFF M107.
Turns OFF M106.
Turns ON M101.
Turns ON M100.
: 1  number of device points  3584, 7168
or 7904
: Communication in ASCII
code
Communication in binary
code
: 1  number of device points  1792, 3584
or 3952
: Communication in ASCII
code
Communication in binary
code
: 1  number of device points  160
: (Head device number + number of device points - 1) 
maximum device number
: 3584 points
: 7168 points
: 7904 points
: 1792 points
: 3584 points
: 3952 points
3 - 88