National Instruments 653 Series User Manual page 145

M
Measurement Studio software, 1-3
memory specifications, A-2
monitoring data transfer, pattern I/O, 2-12
monitoring line state. See change detection
N
National Instruments support and services, F-1
National Instruments, application
software, 1-3
NI support and services, F-1
NI-DAQ driver software, overview, 1-4
O
open-collector output, unstrobed I/O, 2-2
optimizing transfer rates
benchmark results
AT-DIO-32HS (table), E-4
DAQCard-6533 for PCMCIA
(table), E-7
PCI-6534 (table), E-8
PCI-7030/6533 with LabVIEW RT
(table), E-10
PCI-DIO-32HS (table), E-5
PXI-6533 (table), E-6
PXI-6533 with LabVIEW RT, E-10
PXI-6534 (table), E-9
maximum transfer rates, E-1
obtaining fastest transfer rates, E-2
optional equipment for connecting
signals, C-7
P
pattern I/O
connecting signals, 2-13
continuous or finite data transfer
continuous input, 2-11
continuous output, 2-11
© National Instruments Corporation
DMA or interrupt transfers, 2-12
finite, 2-11
internal or external REQ source, 2-7
maximum transfer rate (table), E-2
monitoring data transfer, 2-12
port and timing controller combinations
(table), 2-6
programming
continuous, in NI-DAQ, 2-15
LabVIEW/LabVIEW RT, 2-16
single buffer, in NI-DAQ, 2-14
REQ polarity, 2-7
specifications, A-3
timing diagrams
external REQ signal source, 3-2
internal REQ signal source, 3-1
transfer direction, 2-7
transfer rate, 2-8
triggering data transfer
pattern-matching trigger (input
only), 2-10
start and stop trigger, 2-9
start trigger, 2-8
stop trigger, 2-9
when to use (table), 2-1
width of data to transfer, 2-6
pattern-matching trigger
change detection, 2-31
input only, pattern I/O, 2-10
PCI-6534 device
benchmark results (table), E-8
block diagram, D-4
installation, 1-7
support for DMA transfers (table), E-3
PCI-7030/6533 device
benchmark results (table), E-10
block diagram, D-3
installation, 1-7
PCI-DIO-32HS
benchmark results (table), E-5
block diagram, D-3
I-7
Index
NI 653X User Manual