Start And Design Of The User Interface; Initial Start Of The User Interface - Siemens SICAM MMU 7KG9663 Device Manual

7.2

Start and Design of the User Interface

7.2.1

Initial Start of the User Interface

Requirements
Before starting the User Interface, the following preconditions must be satisfied:
✧
Assemble the SICAM MMU as described in chapter 5.2.
✧
Connect the lines for measurement, communication and supply voltage as described in chapter 5.3 and
observe the safety provisions.
✧
Switch on the devices needed for the measurement.
✧
Switch on the supply voltage of the SICAM MMU.
✧
Check whether the LEDs at the SICAM MMU indicate that the device is ready (see chapter 12.3).
✧
Match the IP address and the subnet mask of the network interface card of your computer to the device
settings.
✧
Check on the computer screen whether the LAN connection is up. Activate the LAN connection if it is down
(see the Windows manual or the Windows online help for information).
✧
For checking purposes, carry out the ping test as follows (example for Windows XP):
−
Click Start on the Windows interface.
−
Select Execute....
−
Enter cmd in the dialog and click OK.
−
Enter: ping 192.168.0.55.
−
Press Enter.
−
Check the following output in the window.
Fig. 7-1
✧
Start Microsoft Internet Explorer.
✧
Enter the IP address in Microsoft Internet Explorer (e.g. default IP address: http://192.168.0.55) of
SICAM MMU and press ENTER.
The User Interface opens with the Information tab → Show device information (see figure 7-4).
SICAM MMU 7KG9663, Device Manual
E50417-H1040-C514-A3, Edition 01.2016
Ping Test
7.2 Start and Design of the User Interface
7 Operation
77