Table of Contents
Advertisement
5.2.2
Assembly
Mount the SICAM MMU to a DIN rail according to EN 60750 in the following way:
Guiding of the
snap-in clip
DIN rail
Fig. 5-2
✧
Pull down the release device at the snap-in clip and hold it in this position.
✧
Slide the device with the guiding of the snap-in clip onto one side of the DIN rail.
✧
Move the device into the desired position on the DIN rail.
✧
Release the release device. The device is now firmly mounted on the DIN rail.
NOTE
The snap-in clip is adjusted to a certain height setting by the manufacturer. You can change this setting if nec-
essary. To do so, lever the release device out of its guiding (no special tool required) and move the release
device into the desired position. Subsequently, press the release device back into its guiding.
UL-certification conditions
Field Wires of Control Circuits shall be separated from other circuits with respect to the end use requirements!
SICAM MMU 7KG9663, Device Manual
E50417-H1040-C514-A3, Edition 01.2016
Pulling direction
Mounting on a DIN Rail
Snap-in clip
Release device
5 Getting Started
5.2 Assembly
45
Advertisement
Table of Contents
