Sony 50P Operating Instructions Manual page 72

Duplication (generating a work tape with the same time code)
Warnings about duplication
If an error occurs during duplication, a STOP/
CAUTION number and warning message will be
displayed on the LCD monitor and the VIDEO OUT1
output screen.
STOP/
Warning Message
CAUTION
No.
RECORDER:
00
[DV IN] NOT SELECTED
i.LINK CABLE:
01
DISCONNECTED
i.LINK CABLE:
02
MULTI CONNECTION
i.LINK CABLE:
03
BUS RESET
PLAYER:
10
RECORDING
PLAYER:
11
NO CASSETTE
PLAYER:
12
UNCONTROLLABLE
PLAYER:
13
UNCONTROLLABLE
PLAYER:
14
UNCONTROLLABLE
PLAYER:
15
NOT DVCAM
PLAYER:
16 UNCONTROLLABLE
PLAYER:
18
TAPE INFO. UNKNOWN
19 a)
PLAYER:
CM ERROR
PLAYER:
21
EMERGENCY STOP
PLAYER:
22
DEW STOP
RECORDER:
35
DVCAM NOT SELECTED
RECORDER:
37
NO CM
RECORDER:
39
CM ERROR
RECORDER:
40
STOP
72
(GB) Chapter 5 Duplication and Audio Dubbing
The following table lists these warnings and messages.
If a warning message is displayed, check this table and
take the appropriate action.
Cause/Remedy
The INPUT SELECT selector on the recorder (this unit) is not set to DV. t Set
the INPUT SELECT selector to DV.
The DV cable is not connected correctly. t Connect the DV cable correctly.
There are multiple DV connections or the DV connection is looped. t You
cannot connect multiple devices. Connect only one player to this unit.
The DV cable has been unplugged and plugged in again. t Check the DV cable
connection. Try to duplicate again.
The player is in the recording mode.
There is no cassette in the player.
The player cannot be controlled, or the duplicate mode has been set to
MANUALq and the cassette in the player has reached the end of the tape.
The player rejects control.
The player is disabled or is in a different mode than the recorder (this unit) has
requested.
The cassette in the player is not recorded in the DVCAM format. t You can
duplicate only a DVCAM recorded tape.
The player has been manually operated or the player's protection function
cancelled the playback pause mode when the duplicate mode was set to
AUTOq or AUTOq.
The cassette information in the player cannot be read. t If the cassette
information is correct, clean the terminal of the cassette and insert the cassette
again (see page 97 (GB)) .
The player could not read the cassette memory during duplication. t If the
cassette memory is correct, insert the cassette again.
The player has detected self-diagnostics. t Refer to the instruction manual of
the player.
Moisture condensation has occurred in the player. t Refer to the instruction
manual of the player.
The DVCAM/DV select switch of the recorder (this unit) is set to DV. t Switch to
DVCAM.
The cassette in the recorder (this unit) does not have cassette memory, but the
recorder tried to duplicate the cassette memory. t Insert a cassette with
cassette memory.
The cassette memory data cannot be written in the cassette in the recorder (this
unit). t Clean the gold-plated terminals on the cassette (see page 97 (GB)).
The recorder (this unit) stopped while duplicating.