Cup Heating Device; Softeners; Regeneration Of The Softener - Wega Wegaconcept Use And Maintenance Manual

14

Cup heating device

The cup heating device is for heating cups before
they are used.
Place the cups to be heated on the appropriate
surface (1).
To turn on the cup heater, press
the ( ) navigator button (it is not
necessary to insert an USB drive); an
asterisk will appear on the first line on
the far right of the display, indicating
that the cup heater is ON.
To turn it off, press the (
navigator button again, the asterisk
will disappear.
To change the temperature of
the cup heater, proceed as listed in
chapter "28-Programming".
!
For safety reasons, it is advisable not to place cloths
or other objects on the cup heater surface (1).
i
If the cup heater is set to a temperature lower than
70 °C in the adjustment menu, it will remain off,
even if switched to ON ( * symbol on the display).
Technical manual
15
build-up of lime scale deposits in the boiler and other
parts of the machine. The softener makes it possible
to eliminate or substantially reduce the presence of
these mineral salts. The resin softener has the property
Cup heater
of retaining the calcium contained in the water. For
ON/OFF
this reason, the resins become saturated after a certain
period and must be regenerated with coarse kitchen salt
(NaCl, sodium chloride) or special water softening salt.
It is very important to regenerate the softener within
) the established times. The regeneration is to be done
regularly every 15 days. However, in locations where
water is very hard, it will be necessary to regenerate
it more frequently. The same rule can be applied to
RESS 3,5 *
locations where there is a large consumption of hot water
14-APR-2010
for tea or other uses.
% P 85%
15.1
1
Softener model
8 liters
12 liters
16 liters

Softeners

Mains water contains insoluble salts, which cause the

Regeneration of the softener

Proceed as follows:
move levers (B) and (E)
from left to right;
remove the lid by loosen-
ing the knob (A);
release enough water
through the pipe (C) to
make room for the salt to
be added, based on the
model (see the table on
the following page);
clean any salt or resin residues from
the gasket located on the cover;
put the cover back in place by screw-
ing the knob (A) down securely and
move the lever (B) back from right
to left;
let the salt water drain from the little
hose (D) until the water is no longer
salty (about 30-60 minutes). The salt
allows the accumulated mineral
salts to be released;
switch the lever (E) from right to
left back to its initial position.
Amount of salt
1.0 kg
1.5 kg
2.0 kg
Wegaconcept
A
B
C
E
D
19