Preparation Of Beverages; Programming The Coffee Doses; Coffee Preparation; Programming The Hot Water Doses - Wega Wegaconcept Use And Maintenance Manual

17

Preparation of beverages

17.1

Programming the coffee doses

To program the dose keys, proceed as follows:
press and hold the "PROG/STOP" key down for 5
seconds: the "PROG/STOP" key will flash and all keys
on the push-button panel being programmed will
turn on;
fill the filter with a dose of ground coffee and press it
with the coffee press;
attach the filter holder to the delivery group;
put the coffee cup under the dispensing spout (16);
press the desired dose
key (e.g.: "1 Espresso"
);
all the leds will turn off,
except for the dose key
being programmed, and
the one on the " PROG/
STOP" key;
wait for dispensing; to
confirm the dose press the dose key or the "PROG/
STOP" key again;
repeat this operation for the other dose buttons;
upon completion of the programming, press the
"PROG/STOP" key to exit dose programming.
i
After 30 seconds of idle time, the machine will exit
from the dose programming mode.
i
The programming of each dose must be carried
out with ground coffee and not with previously
used grounds.
It is possible to program all machine's push-button
panels simultaneously using only the left push-
!
button panel. To obtain different doses for the
various groups, perform the programming with
the left push-button panel first, and then with all
the others.
Technical manual
16
17.2

Coffee preparation

Fill the filter with a dose of ground coffee and press
it with the coffee press;
attach the filter holder to the delivery group;
put the coffee cup under the dispensing spout;
press the desired dose key (e.g.: "1 Espresso"
and wait for coffee to be delivered (the LED of the
selected key will go out).
to stop delivery of coffee in advance, press the deliv-
ery key again or press the "PROG/STOP" key.
17.3

Programming the hot water doses

To programme the
hot water key, proceed as
follows:
place the cup under the
hot water nozzle (13);
press and hold down
the "PROG/STOP" key
on the left push-button
panel until all dose key
LEDs are switched on;
press the hot water de-
livery key ;
when the desired dose has been reached, confirm by
pressing the hot water key
upon completion of the programming, press the
"PROG/STOP" key.
All models are provided with 2 keys for the delivery
i
of hot water. These can be programmed individually
and supply doses which are independent from one
another.
i
The 4GR version has 2 hot water nozzles. The left key
controls the left hot water nozzle, while the right key
controls the right hot water nozzle.
Wegaconcept
12
again.
21
)