Cup Heating Device; Illuminated Side; Description; Preparing The Remote Control - Wega Concept Use And Maintenance Manual

!
When the software is updated, as soon as the
machine is started the system loads the default
data. In this case you will need to set the machine
parameters again.
10

Cup heating device

The cup heating device is for heating cups before
they are used.
Place the cups to be heated on the
appropriate surface (1).
To turn on the cup heater, press
the () navigator button (it is not
necessary to insert an USB drive); an
asterisk will appear on the fi rst line on
the far right of the display, indicating
thatthe cup heater is ON.
To turn it off, press the ( )
navigator button again, the asterisk
will disappear.
To change the temperature of
the cup heater, proceed as listed in
chapter "23-Programming".
!
For safety reasons, it is advisable not to place cloths
or other objects on the cup heater (1).
!
If the cup heater is set to a temperature lower than
70 °C in the adjustment menu, it will remain off ,
even if switched ON ( * symbol on the display).
Technical manual
DATA
REGISTER RESET
Cup heater
ON/OFF
RESS 3.5 *
14-APR-2010
% P 85%
1
11

Illuminated side

11.1

Description

Within each side of the body, there is a drowned strip
with LEDs.
They provide uniform and adjustable lighting along
the perimeter on the same side, which can be activated
at user's discretion.
This chapter provides instructions for adjusting and
turning on/off one or both lit sides.
To activate and deactivate the lighting
of the delivery compartments, as well as
of the sides of the machine, press the ()
navigator button repeatedly.
The lights will switch on sequentially,
depending on how many times the
button is pressed.
T h e t a b l e b e l o w s h o w s t h e
correspondence between the number of
presses and the switching on of the lights.
no. of presses on the Dispensing
button () compartment light
1
2
3
4
i
The ON/OFF lights button works as a main switch.
The internal dimmer and the remote control cannot
switch on the sides if these were set to OFF by the
main switch.
11.2

Preparing the remote control

• Open the battery cover on the back of the
remote control.
• Insert two AAA batteries. Make sure the polar-
ity (+ and -) is aligned correctly.
• Put the battery cover back in place.
!
Dispose of the batteries in compliance
with the environmental regulations in
use. Do not dispose of them together with
the household waste.
Wegaconcept
ON/OFF
Lights
Sides light
ON OFF
ON ON
OFF ON
OFF OFF
19