Tyre Pressure; Accessories; Controls; Mechanical Accessory Lift Pedal (11:A) - Stiga Villa Spring Instruction Manual

(Translation of the Original Instructions)
the work tool in the cutting-means assembly arms
(10:O).
5 .8

TYRE PRESSURE

For the tyre pressure, please refer to chap. "0
TECHNICAL DATA TABLE".
5 .9

ACCESSORIES

For installation of accessories, see the installation
guide accompanying each accessory.
Note: In this case the cutting device
assy is considered an accessory .

6 CONTROLS

6 .1 MECHANICAL ACCESSORY LIFT PE-
DAL (11:A)
The control lever (11:A1) is used to take the
accessories from the operating position to the
transport position.
• Transport position: press the pedal right down
then lift your foot off: the pedal stays down.
• Working position: press and slowly release the
pedal.
Do not attempt to switch to the tran-
sport position while the hooked-up
accessory is in operation . This will de-
stroy the drive belt .
6 .2 PARKING BRAKE PEDAL mod .:[Gear]
(11:B)
Combined brake/clutch pedal. The pedal (11:B)
has the following three positions:
engaged. If the machine is in
gear and the pedal is
released, the machine will
move accordingly. The brake
is not on.
Pressed to halfway: Forward drive disengaged.
In this position it is possible to change gear. The
brake is not on.
Pressed right down . Forward drive disengaged.
The brake is on.
Do not regulate driving speed by acting
on the clutch pedal and letting it slip .
Put the machine a more suitable gear .
Released: Forward drive
ENGLISH
6 .3 PARKING BRAKE MODELS: [Hydrosta-
tic] (11:B)
The pedal (11:B) has the following three positions:
brake is not activated.
Pressed right down . Forward drive disengaged.
The parking brake is fully activated but not locked.
This position is also used as an emergency brake.
6 .4 PARKING BRAKE LOCKING LEVER
(11:C)
The lever locks the "brake" pedal in the
pressed right down position. This function
is used to lock the machine on slopes, du-
ring transport, etc., when the engine is not running.
Locking:
1 . Press the pedal (11:B) right down.
2 . Move the locking lever (11:C) to the right.
3 . Release the pedal (10:B).
4 . Release the locking lever (11:C).
Unlocking:
1 . Press and release the pedal (10:B).
6 .5

TRACTION PEDAL [Hydrostatic] (13:E)

The pedal determines the gearing ratio between
the engine and the drive wheels (= the speed).
When the pedal is released, the service brake is
activated.
- Press the pedal forward – the
machine moves forward.
- No load on the pedal – the machine is
stationary.
- Press the pedal backward – the
machine reverses.
- Reduce the pressure on the pedal – the machine
brakes.
A plate is installed on the upper section of the pe-
dal which can be adjusted to suit the driver's foot.
If the machine does not brake as ex-
pected when the pedal is released, the
left pedal (11:B) should be used as an
emergency brake .
6 .6

STEERING WHEEL (If scheduled) (13:H)

The height of the steering wheel is fully adjustable.
Unscrew the adjustment knob (13:D) on the stee-
Released: The clutch is not
activated. The parking brake is
not activated.
Pressed to halfway: Forward
drive disengaged. The parking
EN
13