Operating Instructions; First Fire; Operation Using An Optional Wall Thermostat - Regency Panorama P121E-NG11 Owners & Installation Manual

First Fire

The FIRST FIRE in your stove is part of the paint
curing process. To ensure that the paint is properly
cured, it is recommended that you burn your fireplace
for at least four (4) hours the first time you use it with
the fan on. When first operated, the unit will release
an odour caused by the curing of the paint and the
burning off of any oils remaining from manufactur-
ing. Smoke detectors in the house may go off at this
time. Open a few windows to ventilate the room for
a couple of hours. The glass may require cleaning.
DO NOT ATTEMPT TO CLEAN THE GLASS WHILE
IT IS STILL HOT!
Note: When the glass is cold and the appli-
ance is lit, it may cause condensation
and fog the glass. This condensation
is normal and will disappear in a few
minutes as the glass heats up.
DO NOT BURN THE APPLIANCE WITH-
OUT THE GLASS FRONT IN PLACE.
During the first few fires, a white film may
develop on the glass front as part of the cur-
ing process. The glass should be cleaned or
the film will bake on and become very difficult
to remove. Use a non-abrasive cleaner and
NEVER clean the glass while it is hot.

Operating Instructions

1) Read and understand these instructions before
operating this appliance.
2) Check to see that all wiring is correct and en-
closed to prevent possible shock.
3) Check to ensure there are no gas leaks.
4) Make sure the glass in the door frame is properly
positioned. Never operate the appliance with the
glass removed. Never strike the glass or slam
the door shut.
5) Verify that the venting and cap are unobstructed.
6) Verify log placement. If the pilot cannot be seen
when lighting the unit - the logs have been incor-
rectly positioned.
7) The unit should never be turned off, and on
again without a minimum of a 60 second wait.
This remote control requires coding. See remote
coding instructions for details.
NOTE: T his appliance will operate with 4 AA back-up
batteries installed (see Back-up Battery section
for details) during power outages. Only the fan
will not operate until power is restored. If the
remote is misplaced, the unit can be shut off
by flipping the main ON/OFF switch, located
on the wall.
IMPORTANT: The remote control system supplied
with this appliance has several options for
starting/operating the appliance, please read the
remote control operating instructions (packed
with remote control) to understand how to
operate this remote system. You can download
remote functions video with the QR code below..
Operation Using an Optional Wall
Thermostat
This appliance ships with a full function remote
control as standard equipment. This allows for basic
on/off function as well as the ability to operate as
a thermostat. With the addition of an optional wall
cradle (820-477-AWT) available from an autho-
rized dealer, the remote can reside on a wall and
carry out all the functions of a typical millivolt wall
thermostat as well as being able to control the fan
speed, accent light and the flame height. This is the
recommended procedure for operating the unit with
a thermostatic set point.
If a millivolt wall thermostat is required for bedroom
installation or as preferred method of controlling the
stove. See noted option.
Wall thermostat and remote. Set the wall thermo-
stat to the desired set point, then place the remote
transmitter in either SMART or thermostatic mode
with a set point 5 degrees above the set point on
the wall thermostat. The burner will fire until the
set point on the wall thermostat is satisfied. The
remote will remain connected and allow full control
of all accessories.
Regency P121E-11/P131E-11 Zero Clearance Direct Vent Gas Fireplace
®
operating instructions
| 45