Framing And Finishing - Regency Panorama P121E-NG11 Owners & Installation Manual

Framing and Finishing

1) For ease of installation, frame your fireplace after it is positioned and the vent system is installed. Remember to install the top standoffs. See the "Unit
Assembly Prior to Installation" section. Use 2x4's and frame to local building codes.
CAUTION: Verify your fireplace dimensions, framing methods and finished wall facing details before framing. Determine the total thickness of
facing material - drywall plus ceramic tiles, slate, etc. Allow the finish surface to be flush with the front or side of the unit. Total facing thickness
can vary from 1/2" (13mm) to 1-1/4" (32mm) thick.
2) When locating your appliance on an exterior wall or in a chase, apply a vapour barrier and drywall, as per local building codes. DO NOT INSULATE THE
FIREPLACE ITSELF.
CAUTION: The unit does not have to be completely enclosed in a chase. The clearance on top of the unit is 0" to the standoffs so combustible
building materials can be laid directly on top of the standoffs. You must maintain clearance from the vent to combustible materials for both rigid
and flex, see Vent Clearances in the "Clearances" section.
P121E-11 - See Thru
P131E-11 - Pier
Note: These units are
non-load bearing.
Framing Dimensions
P121E-11 (See Thru)
A 25"(635mm)
m inus 2X the finishing
material thickness*
B 42-1/2"(1080mm)
C 46-3/4"(1187mm)
* Finish material thickness includes: drywall, ceramic tile, slate, etc.
P121 only: The appliance extends 2-3/4" inches further on the vent side.
If trying to center the appliance in a room add 2-3/4" to the non vent side
when framing. Do not however change dimension (C) as the opening
remains the same.
Regency P121E-11/P131E-11 Zero Clearance Direct Vent Gas Fireplace
®
installation
P131E-11 (Pier)
A 25"(635mm)
m inus 2X the finishing
material thickness*
B 42-1/2"(1080mm)
C 45" (1143mm)
m inus 1X the finishing
material thickness*
| 19