Log Set Installation - Regency Panorama P121E-NG11 Owners & Installation Manual

installation

Log Set Installation

Read the instructions below carefully and refer to the
diagrams. If logs are broken do not use the unit until
they are replaced. Broken logs can interfere with the
pilot operation.
Log Kit # 360-930 contains the following pieces:
a) 326 Front Right Log
b) 327 Front Left Log
c) 328 Middle Right Log
d) 329 Middle Left Log
e) Embers (902-154)
f) Platinum Embers (946-669) -
aged manual
Please note that there are 2 of each log.
This log set is mirrored front and back.
327
The 3-digit numbers (ie. 327) are molded into the rear of each log.
1) Carefully remove the logs from the box and unwrap
them. The logs are fragile, handle with care - do not
force into position.
2) Place embers on the burner as shown below.
Separate platinum embers and place on the burner
over top of and around embers. Platinum embers can
cover burner ports. Avoid stacking platinum embers.
When placing Embers, do not block burner ports
as this can cause an incorrect fl ame pattern,
carbon deposits and delayed ignition.
918-111c
|
38
Regency P121E-11/P131E-11 Zero Clearance Direct Vent Gas Fireplace
®
LOG SET INSTALLATION
supplied with pack-
326
328
329
IMPORTANT
3) Place Log 326 on the front right side of the burner.
Ensure that the notches on the far right side of the log
fi t into the grate posts. Push back side of the left end
of the log up against the tab on the burner.
326
Push back side of the left end of the log up
against the tab on the burner.
Repeat step 3 on the opposite side of the burner.
326
4) Place Log 327 on the front left side of the burner. Po-
sition the right end of the log in between the two tabs
and the left end of the log into the grate post.
Grate Post
Page 1 of 2
P121 / P131
327
Tab on Burner
326
01/03/08