Figure 9−10. Time Setup Screen - Eaton Powerware 9315 Installation And Operation Manual

Select Time from the Setup menu to display the Time Setup screen. The Time
Setup screen allows you to set the internal time stamp of the UPS. The time stamp
is used for logging events in the Event History Log. Figure 9−10 shows the Time
Setup screen.
UPS System Normal
ALARM: NONE
NOTICES: NONE
Battery
Minutes
48.5
Setup
Port 1
Port 2
Time
Language
Meters Events
The small return arrow (
screen. This arrow is a reminder that you can press the
Monitor Panel to toggle the pushbuttons between the menu box and the
information area. When the scroll bar is in the information area, the return arrow is
in the menu box. When the scroll bar is in the menu box, the return arrow is in the
information area.
When the scroll bar appears in the information area, you can use the pushbuttons
to change the time stamp settings. To change a setting in the time stamp, press
the and
the setting (make it a higher value), press the
setting (make it a lower value), press the
settings upon exit from this screen, be sure the SAVE field is set to YES.
9−12
Uninterruptible Power System
DAY DT
MON 07
Statistics Graphics
Figure 9−10. Time Setup Screen
) appears in the upper right corner of the Time Setup
pushbuttons to highlight the setting you want to change. To increase
15 JUL 1998
Set Time & Date
MON YR HR:MN SAVE
APR 97 15:06 YES
Setup
pushbutton. To decrease the
pushbutton. If you want to save the
EATON Powerware 9315 Parallel Capacity/Redundant System
164201150
09:25:42
pushbutton on the
Rev. E www.powerware.com