System Event Messages - Eaton Powerware 9315 Installation And Operation Manual

12.4 System Event Messages

When a system event occurs, a message is added to the Event History Log. A
message may also appear on the Monitor Panel of the SSBM or UPM. The Event
History Log contains all system event messages, whether or not they were
displayed on the Monitor Panel. The following list contains the programmable
events displayed on the Active screen of the Monitor panel.
INVERTER ALARMS
Inverter Failure
Inverter AC Over Voltage
Inverter AC Under Voltage
Inverter Over Frequency
Inverter Under Frequency
Inverter DC Over Voltage
Bypass Phase Rotation
Inverter Phase Rotation
Service Required
UPS Tripped
Shutdown Imminent
UPS Off
Battery Contactor (K2) Failed
Bypass Contactor (K4) Failed
Inverter Contactor (K3) Failed
Bypass Control Failed
Check Unit Setup
Bypass Contactor (K4) Fail
Battery Ground Fault
100% Overload Shutdown
125% Overload Shutdown
Over Temperature Shutdown
Network Sync Failure
Inverter Calibration Required
Inverter Setup Required
12−2 EATON Powerware 9315 Parallel Capacity/Redundant System
164201150 Rev. E www.powerware.com