Firmware - ZyXEL Communications MAX-207HW2 User Manual

Chapter 9 The System Configuration Screens
Table 34 ADVANCED ( 進階 ) > System Configuration ( 系統組態 ) > Dynamic DNS
LABEL
IP Address Update Policy (IP 位址更新原則 )
Use WAN IP
Address ( 使用
WAN IP 位址 )
Dynamic DNS
server auto
detect IP
address ( 動態
DNS 伺服器自動
偵測 IP 位址 )
Use specified IP
address ( 使用指
定的 IP 位址 )
Apply ( 套用 )
Reset ( 重設 )

9.3 Firmware

Click ADVANCED ( 進階 ) > System Configuration ( 系統組態 ) > Firmware to
upload new firmware to the WiMAX Modem. Firmware files usually use the system
model name with a "*.bin" extension, such as "WiMAX Modem.bin". The upload
process uses HTTP (Hypertext Transfer Protocol) and may take up to two minutes.
After a successful upload, the system will reboot.
Contact your service provider for information on available firmware upgrades.
Note: Only use firmware for your WiMAX Modem's specific model.
Figure 41 ADVANCED ( 進階 ) > System Configuration ( 系統組態 ) > Firmware
102
DESCRIPTION
Select this if you want the WiMAX Modem to update the domain name
with the WAN port's IP address.
Select this if you want the DDNS server to update the IP address of the
host name(s) automatically. Select this option when there are one or
more NAT routers between the WiMAX Modem and the DDNS server.
Note: The DDNS server may not be able to detect the proper IP
address if there is an HTTP proxy server between the
WiMAX Modem and the DDNS server.
Select this if you want to use the specified IP address with the host
name(s). Then, specify the IP address. Use this option if you have a
static IP address.
Click to save your changes.
Click to restore your previously saved settings.
User's Guide