The Lan Configuration Screens; Overview; What You Can Do In This Chapter; What You Need To Know - ZyXEL Communications MAX-207HW2 User Manual

C
H A P T E R

The LAN Configuration Screens

5.1 Overview

Use the ADVANCED > LAN Configuration screens to set up the WiMAX Modem
on the LAN. You can configure its IP address and subnet mask, DHCP services, and
other subnets. You can also control how the WiMAX Modem sends routing
information using RIP.
A Local Area Network (LAN) is a shared communication system to which many
computers are attached. A LAN is usually a computer network limited to the
immediate area, such as the same building or floor of a building.

5.1.1 What You Can Do in This Chapter

• The DHCP Setup screen
configure the DHCP server in the WiMAX Modem.
• The Static DHCP screen
addresses to specific computers on the LAN.
• The IP Alias screen
port. You can also control what routing information is sent and received by each
subnet.
• The IP Static Route screen
static routes configured in the WiMAX Modem.
• The Other Settings screen
routing information that is sent and received by each subnet assign specific IP
addresses to specific computers on the LAN.

5.1.2 What You Need to Know

The following terms and concepts may help as you read through this chapter.
IP Address
IP addresses identify individual devices on a network. Every networking device
(including computers, servers, routers, printers, etc.) needs an IP address to
User's Guide
(Section 5.2 on page
(Section 5.3 on page
(Section 5.4 on page 49) lets you add subnets on the LAN
(Section 5.5 on page
(Section 5.6 on page
5
46) lets you enable, disable, and
47) lets you assign specific IP
51) lets you examine the
53) lets you control the
45