ZyXEL Communications MAX-207HW2 User Manual page 180

Table 68 Standards Supported (continued)
STANDARD
RFC 3611
RFC 3715
RFC 3842
IEEE 802.3
IEEE 802.3u
Table 69 Voice Features
Call Park and
Pickup
Call Return
Country Code
Do not Disturb
(DnD)
Auto Dial
Phone config
User's Guide
DESCRIPTION
RTP Control Protocol Extended Reports (RTCP XR)-XR
IP Sec/NAT Compatibility
A Message Summary and Message Waiting Indication Event
Package for the Session Initiation Protocol (SIP)
10BASE5 10 Mbit/s (1.25 MB/s)
100BASE-TX, 100BASE-T4, 100BASE-FX Fast Ethernet at 100
Mbit/s (12.5 MB/s) with auto-negotiation
Call park and pickup lets you put a call on hold (park) and then
continue the call (pickup). The caller must still pay while the call is
parked.
When you park the call, you enter a number of your choice (up to
eight digits), which you must enter again when you pick up the call. If
you do not enter the correct number, you cannot pickup the call. This
means that only someone who knows the number you have chosen
can pick up the call.
You can have more than one call on hold at the same time, but you
must give each call a different number.
With call return, you can place a call to the last number that called
you (either answered or missed). The last incoming call can be
through either SIP or PSTN.
Phone standards and settings differ from one country to another, so
the settings on your WiMAX Modem must be configured to match
those of the country you are in. The country code feature allows you
to do this by selecting the country from a list rather than changing
each setting manually. Configure the country code feature when you
move the WiMAX Modem from one country to another.
This feature allows you to set your phone not to ring when someone
calls you. You can set each phone independently using its keypad, or
configure global settings for all phones using the command line
interpreter.
You can set the WiMAX Modem to automatically dial a specified
number immediately whenever you lift a phone off the hook. Use the
Web Configurator to set the specified number. Use the command line
interpreter to have the WiMAX Modem wait a specified length of time
before dialing the number.
The phone configuration table allows you to customize the phone
keypad combinations you use to access certain features on the
WiMAX Modem, such as call waiting, call return, call forward, etc. The
phone configuration table is configurable in command interpreter
mode.
Chapter 18 Product Specifications
181