BMW S 1000 XR Rider's Manual page 75

Individualising LAPTIMER
Activating default reading
( 81).
The odometer reading (
appears on the display.
Short-press INFO 2.
The LAPTIMER is called
up and shows in the
RUN
factory settings
BESTLAP
4.
If you want to change the
content of lines 3 and 4 in
the LAPTIMER, repeatedly
long-press INFO 2 until lines 3
and 4 show the readings you
want.
Your chosen LAPTIMER
display layout is accepted and
saved in memory.
LAPTIMER display layout
( 82)
Starting timing
The LAPTIMER is called up.
ODO
)
3 and
Press button 1 to start timing.
NOTICE
The engine has to be running
and the vehicle moving in order
for the headlight-flasher signal to
be detected.
RUN
Timing 2 is running.
Every time you cross the start/
finish line, press button 1 again
to start timing for the next lap.
The data of the preceding lap
are written into memory.
RUN
2 starts again at
00:00:00
.
Timing continues even if you
exit the display mode. In the
other modes, however, timing
of another lap can be started
only by an external signal.
Infrared receiver
An infrared signal provides a con-
venient way of operating the
LAPTIMER. In these circum-
stances, note the following:
The infrared receiver available
as an optional accessory has to
be connected to the plug for
optional accessories located
underneath the right side panel
( 179).
4
73
z