6
100
Press starter button 1.
z
NOTICE
The start attempt is automatic-
ally interrupted if battery voltage
is too low. Recharge the battery
before you start the engine, or
use jump leads and a donor bat-
tery to start.
See the subsection on jump
starting in "Maintenance" for
more details.
The engine starts.
Consult the troubleshooting
chart below if the engine re-
fuses to start. (
Pre-Ride-Check
The instrument panel runs a
test of the warning lights, the re-
volution counter and the display
when the ignition is switched on:
this is the Pre-Ride-Check. The
test is aborted if you start the en-
gine before it completes.
Phase 1
with alarm system (DWA)
LED 1 briefly flashes red.
"General" warning light 2 shows
red.
188)
All the segments in the display
light up.
Telltale and warning lights 4
show.
with cruise control
Depending on the equipment
configuration, telltale and warning
lights 5 show.
Needle 3 of the revolution
counter moves all the way to the
position for maximum engine
revolutions.
Phase 2
'General' warning light 2 changes
from red to yellow.
Phase 3
OE
The needle of the revolution
counter moves to the position
for zero engine revolutions.
The telltale and warning lights go
out or assume operational status,
as applicable.
OE