Advanced Display Module
(ADM)
Upgrade Software (16K743)
NOTE: Back up the custom language file (if installed)
before upgrading software. See USB Data, page 63, for
more information.
1. Turn off power to the system.
2. Remove token access panel, and then remove the
key token (do not discard token).
Access Panel
F
. 44: Remove Access Panel
IG
3. Insert and press software token firmly into slot.
NOTE: There is no preferred orientation of token.
Token
F
. 45: Insert Token
IG
4. Turn on power to the system. The red indicator light
(BL) will flash until new software is completely
loaded.
5. After the red indicator light shuts off, turn off power
to the system.
6. Remove software token.
7. Reinstall blue key token, and replace token access
panel.
Cleaning
Use any alcohol-based household cleaner, such as
glass cleaner, to clean the display.
3A2098S
Upgrade Gateway Module
Software (16K743)
NOTE: The Gateway module connection to the system
is temporarily disabled during the use of upgrade
tokens. The following instructions apply to all Gateway
modules.
1. Turn off power to the system.
2. Remove the access cover.
r_24E451_3B9900_3a
F
IG
3. Insert and press token firmly into slot.
NOTE: There is no preferred orientation of token.
4. Press and hold the button shown in F
BL
r_24E451_3B9900_4a
F
IG
5. After the red indicator light shuts off, turn off power
6. Remove token.
7. Replace access cover.
. 46: Remove Access Cover
second, then release. The red indicator light (CK)
will flash until new software is completely loaded.
CK
Token
. 47: Insert Token
to the system.
Maintenance
Access
Cover
TI12319A
. 47 for ~1
IG
TI12320A
Press Button
81