Key Tokens - Graco PrecisionSwirl Instructions-Parts List Manual

Key Tokens

The ADM and FCM must each have a key token
installed in order to operate. If the incorrect key token is
installed, the module will not operate. The DGM does
not require a key token.
ADM
F . 11
IG
NOTE: There is one FCM located on each fluid plate.
If a new ADM or FCM is installed, follow the instructions
on page 81 to upgrade the software in the new module
and to install the key token from the old module in the
new module.
The following is a list of key token part numbers. If you
lose your key token be sure to order the correct item to
ensure proper system operation.
3A2098S
NOTE: The key tokens for the ADM and FCM look alike
but only work in one module or the other. If the key
tokens for the ADM and FCM become mixed, locate the
part number on each token then refer to the following
table to determine which module each token applies to.
Part
16M100
FCM
16M101
16M102
16M103
16M104
16M105
16M217
Description
FCM Key Token, 2 styles, Flow Meter,
ADM required
FCM Key Token, 2 styles, No Flow Meter,
ADM required
FCM Key Token, 16 styles, Flow Meter,
Integrator Mode Enabled, ADM not
required
FCM Key Token, 16 styles, No Flow
Meter, Integrator Mode Enabled, ADM not
required
FCM Key Token, 256 styles, Flow Meter,
Integrator Mode Enabled, ADM not
required
FCM Key Token, 256 styles, No Flow
Meter, Integrator Mode Enabled, ADM not
required
ADM Key Token, Standard PCF
Overview
23