Ieee802.11B Interface Unit Type H (G813-45)/Type I (G874-39) - Ricoh Neptune-P1 Service Manual

Undo Exec
"Undo Exec" (SP5873-2) restores an application to its original SD card. The application is moved from
Slot 3 to Slot 1 (or Slot 2).
1. Turn off the main power switch.
2. Remove the SD card slot cover (x1).
3. Insert the SD card that currently holds the application in Slot 3.
4. Insert the original SD card to receive the restored application in Slot 1.
• The SD card to receive the restored application can be set in Slot 2, but in this case Slot 1 must
be empty. (The application always moves to Slot 1 by default if there are SD cards in both Slot
1 and Slot 2.)
5. Turn on the main power switch.
6. Enter the SP mode and do SP5873-2 "Undo Exec."
7. Follow the messages on the operation panel to complete the procedure.
8. Exit the SP mode.
9. Turn off the main power switch.
10. Remove both SD cards.
11. Insert the SD card with the restored application in Slot 1 or 2.
12. Turn on the main power switch.
13. Check that the application operates normally.

IEEE802.11b Interface Unit Type H (G813-45)/Type I (G874-39)

Accessories
Check the accessories and their quantities against the table below.
Installation of MFP Options
1
95