802.11B Interface Unit Type A - Ricoh AP600N Setup Manual

802.11b Interface Unit Type A

Note
❒ Depending on the model you use,
the 802.11b Interface Unit, the 1394
Interface Unit, and the Bluetooth
Interface Unit cannot be installed
to the printer at the same time. For
more information, see p.19 "In-
stalling Options".
Important
❒ Before touching the 802.11b Inter-
face Unit, touch something metal
to discharge any static electricity.
Static electricity can damage the
802.11b Interface Unit.
❒ Do not subject the 802.11b interface
unit to physical shocks.
A A A A
Check the contents of the box for
the following items:
• 802.11b Interface Unit
• Card
• Antenna Cap
• Installation Guide
B B B B
Be sure to check the following
points:
• The power switch is turned off.
• The interface cable is un-
plugged from the printer.
Note
❒ If the Duplex Unit is not at-
tached, go to step
C C C C
D D D D
D
.
802.11b Interface Unit Type A
If the Duplex Unit is attached,
push down the lever on right side
(A A A A ) and pull out the Duplex Unit
until it stops (B B B B ).
Remove the two screws holding
the controller board in place.
Note
❒ Use a coin or similar object if the
screws do not turn easily.
❒ These screws are used again in
N
step .
2
ZKGX320E
ZKGX280E
33