Sp1-Xxx Feed - Ricoh Neptune-P1 Service Manual

SP1-xxx Feed

1001 LEdge Reg
1 1st Roll
2 2nd Roll
3 Cassette
5 By-pass Feed
1002 S-to-S Reg
1 1st Roll
2 2nd Roll
3 Cassette
5 By-pass Feed
1105 FTemp Adj
Be sure to switch the main power switch off and on after adjustment.
Cy Rdy Temp
Sets the copy ready fusing temperature. The setting is the difference from the target fusing
temperature that is set with SP1931. DFU
1 [0 to +20/10/1°C]
Copying can start at this temperature before the hot roller reaches its target temperature
(SP1931).
Low Power Mode
Sets the copy ready temperature for low power mode.
3
[80 to 150/90/1°C step]
FTemp Calib
5 Calibrates the scale for the fusing temperature settings. DFU
Adjusts the leading edge registration for printing. To move the image down
the page, increase the value.
[-10.0 to +10.0/ 0 /0.1 mm step]
Adjusts the side-to-side registration for printing.
[-10.0 to +10.0/ 0 /0.1 mm step]
• To move the start position to the right, increase the value (+).
• To move the start position to the left, decrease the value (–).
Note: If you use paper 914 mm wide, adjust within the range of ±2
mm. If you set the adjustment outside this range, part of the image
will be cut off.
Copy Ready Temperature
Fusing Temperature Calibration
Leading Edge Registration
Side-to-Side Registration
Fusing Temperature Adjustment
SP1-xxx Feed
5
247