Paper Set Sensor, Registration Sensor - Ricoh Neptune-P1 Service Manual

21. Close the upper unit. Make sure that the upper unit locks on each side.
22. Switch the main power switch on.
23. Go into the SP mode, enter the developer lot numbers, then mix the developer and initialize the ID
sensor.
• First, do SP2801-2 and -3 to enter the lot numbers of both developer packs.
• You must enter the lot numbers with SP2801-2 and -3 before doing SP2801-1. The
machine will return an error ("Failed") if you attempt to do SP2801-1 before SP2801-2
and -3. If the lot numbers are the same, just enter the same number twice.
• Do SP2801-1 to mix the developer and initialize the ID sensor.

Paper Set Sensor, Registration Sensor

1. Idle registration roller panel (See p.116 "Idle Registration Roller Panel".)
2. Sensor bracket [A] ( x 1)
3. Paper set sensor [B] ( x 1)
4. Registration sensor [C] ( x 1)
Development
3
129