802.11B Interface Unit Type A - Ricoh AP2610 Setup Manual

802.11b Interface Unit Type A

Note
❒ Depending on the model you use,
the 802.11b Interface Unit, the 1394
Interface Unit, and the Network
Interface Board cannot be installed
to the printer at the same time. For
more information, see p.11 "In-
stalling Options".
Important
❒ Before touching the 802.11b Inter-
face Unit, touch something metal
to discharge any static electricity.
Static electricity can damage the
802.11b Interface Unit.
A A A A
Check the contents of the box for
the following items:
• 802.11b Interface Unit
• Installation Guide
B B B B
Confirm that the followings are
true:
• The power switch is turned off.
• The interface cable is un-
plugged from the printer.
Note
❒ If the Duplex Unit is not at-
tached, go to step
C C C C
If the Duplex Unit is attached,
push down the lever on right side
(A A A A ) and pull out the Duplex Unit
until it stops (B B B B ).
D D D D
E E E E
D
.
F F F F
ZGDX320J
802.11b Interface Unit Type A
Use a coin to remove the two
screws.
Note
❒ These screws are used again in
N
step .
Pull out the handle of the control-
ler board.
Pull the handle and slide the con-
troller board out.
2
ZGDX280J
ZGDX370J
ZGDX260J
29