Cisco IE-4000 Software Configuration Manual page 543

Configuring SNMP
How to Configure SNMP
Command
4. snmp-server group groupname {v1 |
v2c | v3 {auth | noauth | priv}} [read
readview] [write writeview] [notify
notifyview] [access access-list]
5. snmp-server host host-addr
[informs | traps] [version {1 | 2c | 3
{auth | noauth | priv}}]
community-string [notification-type]
6. snmp-server enable traps
notification-types
7. snmp-server trap-source interface-id
Purpose
Configures an SNMP group.
Specifies the recipient of an SNMP trap operation.

host-addr—Specifies the name or Internet address of the host (the
targeted recipient).

(Optional) informs—Specifies SNMP informs to be sent to the host.

(Optional) traps (the default)—Specifies SNMP traps to be sent to the
host.

(Optional) Specifies the SNMP version (1, 2c, or 3). SNMPv1 does
not support informs.

(Optional) Version 3—Selects authentication level auth, noauth, or
priv.
Note: The priv keyword is available only when the cryptographic
software image is installed.

community-string—When version 1 or version 2c is specified, enters
the password-like community string sent with the notification
operation. When version 3 is specified, enter the SNMPv3
username.
Note: The @ symbol is used for delimiting the context information. Avoid
using the @ symbol as part of the SNMP community string when
configuring this command.

(Optional) notification-type—Specifies a notification type. Use the
keywords listed in Table 54 on page
notifications are sent.
Enables the switch to send traps or informs and specifies the type of
notifications to be sent. For a list of notification types, see
page 532, or enter snmp-server enable traps ?
To enable multiple types of traps, you must enter a separate
snmp-server enable traps command for each trap type.
Note: When you configure a trap by using the notification type
port-security, configure the port security trap first, and then configure
the port security trap rate:

snmp-server enable traps port-security

snmp-server enable traps port-security trap-rate rate
(Optional) Specifies the source interface, which provides the IP address
for the trap message. This command also sets the source IP address for
informs.
539
532. If no type is specified, all
Table 54 on