Setting The Sdm Template - Cisco IE-4000 Software Configuration Manual

Configuring SDM Templates
How to Configure the Switch SDM Templates
How to Configure the Switch SDM Templates

Setting the SDM Template

Command
1. configure terminal
2. sdm prefer {default | dual-ipv4-and-ipv6
{default} | routing}
3. end
4. reload
Configuration Examples for Configuring SDM Templates
Configuring IP Services Templates: Examples
This is an example of output from the show sdm prefer default command:
Switch# show sdm prefer default
"IPv4 default" template:
The selected template optimizes the resources in
the switch to support this level of features for
8 routed interfaces and 1024 VLANs.
number of unicast mac addresses:
number of IPv4 IGMP groups + multicast routes:
number of IPv4 unicast routes:
number of directly-connected IPv4 hosts:
number of indirect IPv4 routes:
number of IPv6 multicast groups:
number of IPv6 unicast routes:
number of directly-connected IPv6 addresses:
number of indirect IPv6 unicast routes:
number of IPv4 policy based routing aces:
number of IPv4/MAC qos aces:
number of IPv4/MAC security aces:
number of IPv6 policy based routing aces:
number of IPv6 qos aces:
number of IPv6 security aces:
This is an example of output from the show sdm prefer dual-ipv4-and-ipv6 default command:
Purpose
Enters global configuration mode.
Specifies the SDM template to be used on the switch:

default—Gives balance to all functions.

dual-ipv4-and-ipv6—Selects a template that supports both
IPv4 and IPv6 routing.
— default—Balances IPv4 and IPv6 Layer 2 functionality.

routing—Maximizes IPv4 routing on the switch.
Use the no sdm prefer command to set the switch to the default
template. The default template balances the use of system
resources.
Returns to privileged EXEC mode.
Reloads the operating system.
16K
1K
18K
16K
2K
0
0
0
0
0.125k
1.875k
1.875k
0
0
0
139