Cisco IE-4000 Software Configuration Manual page 629

Configuring QoS
Configuring QoS
Command
1. configure terminal
2. class-map [match-all | match-any]
child-class-map-name
3. match {access-group
acl-index-or-name | cos cos-list | ip
dscp dscp-list | ip precedence
ip-precedence-list | qos-group value |
vlan vlan-list}
Purpose
Enter global configuration mode.
Create a class map, and enter class-map configuration mode. By default,
no class maps are defined.

(Optional) Use the match-all keyword to perform a logical-AND of
all matching statements under this class map. All match criteria in
the class map must be matched.

(Optional) Use the match-any keyword to perform a logical-OR of
all matching statements under this class map. One or more match
criteria must be matched.

For class-map-name, specify the name of the class map.
If no matching statements are specified, the default is match-all.
Note: A match-all class map cannot have more than one classification
criterion (match statement).
Define the match criterion to classify traffic. By default, no match
criterion is defined.
Only one match type per class map is supported, and only one ACL per
class map is supported.

For access-group acl-index-or-name, specify the number or name
of an ACL. Matching access groups is supported only in input policy
maps.

For cos cos-list, enter a list of up to four CoS values in a single line
to match against incoming packets. Separate each value with a
space. You can enter multiple cos-list lines to match more than four
CoS values. The range is 0 to 7.

For ip dscp dscp-list, enter a list of up to eight IPv4 DSCP values to
match against incoming packets. Separate each value with a space.
You can enter multiple dscp-list lines to match more than eight DSCP
values. The numerical range is 0 to 63. You can also configure DSCP
values in other forms. See
page 578.

For ip precedence ip-precedence-list, enter a list of up to four IPv4
precedence values to match against incoming packets. Separate
each value with a space. You can enter multiple ip-precedence-list
lines to match more than four precedence values. The range is 0 to
7.

For qos-group value, specify the QoS group number. The range is 0
to99. Matching of QoS groups is supported only in output policy
maps.

For vlan vlan-list, specify a VLAN ID or a range of VLANs to be used
in a parent policy map for per-port, per-VLAN QoS on a trunk port.
The VLAN ID range is 1 to 4094.
625
Classification Based on IP DSCP,