Configuring Mac Address Move Notification Traps; Configuring Mac Threshold Notification Traps - Cisco IE-4000 Software Configuration Manual

Performing Switch Administration
How to Perform Switch Administration

Configuring MAC Address Move Notification Traps

When you configure MAC-move notification, an SNMP notification is generated and sent to the network management
system whenever a MAC address moves from one port to another within the same VLAN.
Command
1. configure terminal
2. snmp-server host host-addr {traps | informs} {version {1 |
2c | 3}} community-string notification-type
3. snmp-server enable traps mac-notification move
4. mac address-table notification mac-move
5. end

Configuring MAC Threshold Notification Traps

When you configure MAC threshold notification, an SNMP notification is generated and sent to the network management
system when a MAC address table threshold limit is reached or exceeded.
Purpose
Enters global configuration mode.
Specifies the recipient of the trap message.

host-addr—Specifies the name or address of the
NMS.

traps (the default)—Sends SNMP traps to the
host.

informs—Sends SNMP informs to the host.

version—Specifies the SNMP version to
support. Version 1, the default, is not available
with informs.

community-string—Specifies the string to send
with the notification operation. You can set this
string by using the snmp-server host
command, but we recommend that you define
this string by using the snmp-server
community command before using the
snmp-server host command.

notification-type—Uses the mac-notification
keyword.
Enables the switch to send MAC address move
notification traps to the NMS.
Enables the MAC address move notification feature.
Returns to privileged EXEC mode.
117