Cisco IE-4000 Software Configuration Manual page 506

Configuring CDP
Additional References
Enabling CDP: Examples
This example shows how to enable CDP on a port when it has been disabled:
Switch# configure terminal
Switch(config)# interface GigabitEthernet1/17
Switch(config-if)# cdp enable
Switch(config-if)# end
Note: Voice VLAN is not counted against port security when CDP is disabled on the switch interface.
This example shows how to enable CDP if it has been disabled:
Switch# configure terminal
Switch(config)# cdp run
Switch(config)# end
Additional References
The following sections provide references related to switch administration:
Related Documents
Related Topic
Cisco IOS basic commands
Cisco IOS system management commands
Switch cluster configuration
Standards
Standards
No new or modified standards are supported by this
feature, and support for existing standards has not
been modified by this feature.
MIBs
MIBs
—
RFCs
RFCs
No new or modified RFCs are supported by this
feature, and support for existing RFCs has not been
modified by this feature.
Document Title
Cisco IOS Configuration Fundamentals Command Reference
Configuring Switch Clusters, page 91
Title
—
MIBs Link
To locate and download MIBs using Cisco IOS XR software, use the
Cisco MIB Locator found at the following URL and choose a platform
under the Cisco Access Products menu:
http://cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml
Title
—
502