Using The Cli To Manage Switch Clusters; Using Snmp To Manage Switch Clusters - Cisco IE-4000 Software Configuration Manual

Configuring Switch Clusters
Managing Switch Clusters
Managing Switch Clusters

Using the CLI to Manage Switch Clusters

You can configure cluster member switches from the CLI by first logging into the cluster command switch. Enter the
rcommand user EXEC command and the cluster member switch number to start a Telnet session (through a console or
Telnet connection) and to access the cluster member switch CLI. The command mode changes, and the Cisco IOS
commands operate as usual. Enter the exit privileged EXEC command on the cluster member switch to return to the
command-switch CLI.
This example shows how to log into member-switch 3 from the command-switch CLI:
switch# rcommand 3
If you do not know the member-switch number, enter the show cluster members privileged EXEC command on the
cluster command switch.
The Telnet session accesses the member-switch CLI at the same privilege level as on the cluster command switch. The
Cisco IOS commands then operate as usual.
Catalyst 1900 and Catalyst 2820 CLI Considerations
If your switch cluster has Catalyst 1900 and Catalyst 2820 switches running standard edition software, the Telnet session
accesses the management console (a menu-driven interface) if the cluster command switch is at privilege level 15. If the
cluster command switch is at privilege level 1 to 14, you are prompted for the password to access the menu console.
Command-switch privilege levels map to the Catalyst 1900 and Catalyst 2820 cluster member switches running
standard and Enterprise Edition Software as follows:

If the command-switch privilege level is 1 to 14, the cluster member switch is accessed at privilege level 1.

If the command-switch privilege level is 15, the cluster member switch is accessed at privilege level 15.
Note: The Catalyst 1900 and Catalyst 2820 CLI is available only on switches running Enterprise Edition Software.
For more information about the Catalyst 1900 and Catalyst 2820 switches, refer to the installation and configuration
guides for those switches.

Using SNMP to Manage Switch Clusters

When you first power on the switch, SNMP is enabled if you enter the IP information by using the setup program and
accept its proposed configuration.
When you create a cluster, the cluster command switch manages the exchange of messages between cluster member
switches and an SNMP application. The cluster software on the cluster command switch appends the cluster member
switch number (@esN, where N is the switch number) to the first configured read-write and read-only community strings
on the cluster command switch and propagates them to the cluster member switch. The cluster command switch uses
this community string to control the forwarding of gets, sets, and get-next messages between the SNMP management
station and the cluster member switches.
Note: When a cluster standby group is configured, the cluster command switch can change without your knowledge. Use
the first read-write and read-only community strings to communicate with the cluster command switch if there is a
cluster standby group configured for the cluster.
If the cluster member switch does not have an IP address, the cluster command switch redirects traps from the cluster
member switch to the management station, as shown in
IP address and community strings, the cluster member switch can send traps directly to the management station, without
going through the cluster command switch.
Figure 13 on page 102. If a cluster member switch has its own
101