Cisco IE-4000 Software Configuration Manual page 122

Performing Switch Administration
How to Perform Switch Administration
Command
1. configure terminal
2. snmp-server host host-addr {traps | informs} {version {1 |
2c | 3}} community-string notification-type
3. snmp-server enable traps mac-notification threshold
4. mac address-table notification threshold
5. mac address-table notification threshold [limit
percentage] | [interval time]
6. end
Purpose
Enters global configuration mode.
Specifies the recipient of the trap message.

host-addr—Specifies the name or address of the
NMS.

traps (the default)—Sends SNMP traps to the
host.

informs—Sends SNMP informs to the host.

version—Specifies the SNMP version to
support. Version 1, the default, is not available
with informs.

community-string—Specifies the string to send
with the notification operation. You can set this
string by using the snmp-server host
command, but we recommend that you define
this string by using the snmp-server
community command before using the
snmp-server host command.

notification-type—Uses the mac-notification
keyword.
Enables the switch to send MAC threshold
notification traps to the NMS.
Enables the MAC address threshold notification
feature.
Enters the threshold value for the MAC address
threshold usage monitoring.

(Optional) limit percentage—Specifies the
percentage of the MAC address table use; valid
values are from 1 to 100 percent. The default is
50 percent.

(Optional) interval time—Specifies the time
between notifications; valid values are greater
than or equal to 120 seconds. The default is 120
seconds.
Returns to privileged EXEC mode.
118