Configuring The Pagp Learn Method And Priority - Cisco IE-4000 Software Configuration Manual

Configuring EtherChannels
How to Configure EtherChannels
Command
1. configure terminal
2. port-channel load-balance {dst-ip | dst-mac |
src-dst-ip | src-dst-mac | src-ip | src-mac}
3. end

Configuring the PAgP Learn Method and Priority

This task is optional.
Command
1. configure terminal
2. interface interface-id
Purpose
Enters global configuration mode.
Configures an EtherChannel load-balancing method.
The default is src-mac.
Select one of these load-distribution methods:

dst-ip—Specifies the destination-host IP address.

dst-mac—Specifies the destination-host MAC address of
the incoming packet.

src-dst-ip— Specifies the source-and-destination host-IP
address.

src-dst-mac—Specifies the source-and-destination
host-MAC address.

src-ip— Specifies the source-host IP address.

src-mac—Specifies the source-MAC address of the
incoming packet.
Returns to privileged EXEC mode.
Purpose
Enters global configuration mode.
Specifies the port for transmission, and enter interface
configuration mode.
1039