Overview - Omron G9SP-N20S Network Connection Manual

4. Overview

This document describes the procedure for connecting a Safety Controller (G9SP series) of
OMRON Corporation (hereinafter referred to as OMRON) with an NJ-series Machine
Automation Controller (hereinafter referred to as the Controller) via serial communications,
and the procedure for checking their connection.
Refer to the serial communications settings of the project file you prepared to understand the
setting method and key points to connect the devices via serial communications.
This project file is used to check a serial connection by sending the monitor I/O command to
the destination device.
Obtain the latest "Sysmac Studio project file" from OMRON beforehand.
Name
Sysmac Studio project file
(extension: SMC)
This document aims to explain the wiring method and communications settings
necessary to connect the corresponding devices and provide the setting
procedure. The program used in this document is designed to check if the
connection was properly established, and is not designed to be constantly used
at a site. Therefore, functionality and performances are not sufficiently taken into
consideration. When you construct an actual system, please use the wiring
method, communications settings and setting procedure described in this
document as a reference and design a new program according to your
application needs.
File name
OMRON_G9SP_SERI232_LD_E
V100.SMC
4. Overview
Version
Ver.1.00
3