Omron G9SP-N20S Network Connection Manual page 16

7.3.3. Checking the Parameters and Building
Check the set parameters, execute the program check on the project data and build the
Controller.
1
Double-click CPU/Expansion
Racks under Configurations
and Setup in the Multiview
Explorer.
2
The CPU/Expansion Racks Tab
is displayed on the Edit Pane.
Select the Serial
Communications Unit icon as
shown on the right.
Confirm that CJ1W-SCU42 is
displayed, the device name is
SCU, and the unit number is 0.
*If the settings are different,
change the values.
Click Edit Special Unit
Settings.
3
The 0 [Unit 0]: Tab is displayed.
Open the pull-down menu of
Parameter group to show and
select Port2: No-Protocol
Settings.
7. Connection Procedure
13