4
Parameter group to show is set
to Port 2: No-Protocol Settings.
The items of the Port 2:
No-Protocol Settings are
displayed.
Confirm that the Port2: Port
settings is set to User settings
and other items are the same as
Section 6.1.
*If the settings are different from
the above, change the values
from the pull-down menu. Click
the Apply Button after
changing values.
5
Double-click I/O Map under
Configurations and Setup on
the Multiview Explorer.
The I/O Map Tab Page is
displayed and the parameters of
the Unit are displayed.
6
Confirm that the data in the
Variable Columns on the I/O
Map Tab Page start with SCU
and that the Global Variables
are set in the Variable Type
Columns.
*If the settings are different from
the above, right-click on
CJ1W-SCU42 and select
Create Device Variable.
7
Double-click the Task Settings
under Configurations and
Setup in the Multiview Explorer.
7. Connection Procedure
14