Additional Information
For details on the errors, refer to A-3 Error Code Details in the NJ-series Instructions
Reference Manual (Cat. No. W502).
For troubleshooting the errors, refer to 9-3 Troubleshooting in the CJ-series Serial
Communications Units Operation Manual for NJ-series CPU Unit (Cat.No. W494).
9.7.2.
Destination Device Error
The error codes for destination device errors are shown below.
The status code (Output_Status) of the destination device error is #16#FF03.
[Destination device error code list]
Meaning
ErrorCode1
Response
rightmost
length
ErrorCode1
Service code
leftmost
ErrorCode2
End code
rightmost
ErrorCOde2
Reserve data
leftmost
at error
response
·Destination device error record function
The response data from the Safety Controller include Present Error Information, Error
Log Count (Operation Log Count), Error Log (Error Code: Conduction Time), Operation
Log (Operation Code: Conduction Time), which are stored in
G9SP_ResponseData[100] and the subsequent variables.
Note that this project does not detect these errors.
Additional Information
For details and troubleshooting the destination device errors, refer to Section 13
Troubleshooting in the G9SP Series Safety Controller Operation Manual (Cat. No. Z922).
Destination device
error code
#16#C3
#16#09
#16#00
#16#xx
#16#CB
#16#xx
#16#0000
#16#xxxx
#16#0000
#16#xxxx
9. Project File
Description
Normal
Error response
No response data
Other errors
Both normal/error response
(#CB is received)
Other errors
Normal
Incorrect command
Normal
Error state
52